Latexplan No Ammonia is a two-part cement-based smoothing compound consisting of a grey powder (part A) containing special cements, graded silica sands and additives, to be mixed with a synthetic rubber latex (part B).

Latexplan No Ammonia can receive light foot traffic after approximately 60 minutes and is ready to receive floor coverings after 4hrs, depending on the ambient temperature. Latexplan No Ammonia has a very low odour, making it suitable for use in confined and inhabited areas, where working and/or occupation needs to be maintained. Latexplan No Ammonia should not be mixed with any additional latex or water.

Latexplan No Ammonia is suitable for levelling differences in thickness between 3mm to 10mm on new and existing substrates. It can be used over most existing adhesive residues, including bitumen. Also suitable for use over plywood substrates and MAPEI surface-applied DPMs in most cases without priming. Accepts subsequent floor coverings in 4 hours. In most cases, priming is not required.

- Suitable for use with underfloor heating.
- Moisture tolerant; can be applied below surface applied damp proof membranes.

*On highly porous and absorbent surfaces, a coat of primer prior to the application will prevent pinholes within the surface, providing a smooth even finish.

Some application examples:
Smoothing plywood, concrete floors, sand: cement screeds, MAPEI Mapecem and Topcem screeds. For smoothing over existing floors in concrete, ceramic and porcelain tiles and natural stone without priming. And over any MAPEI surface applied DPMs